20 years of focus on custom button production, custom samples, complete varieties.
Hotline : 0573-84563560/0573-84799376

Sharing of dry goods

* : * : admin * : 2020/03/23 13:40:42 * : 0
The five-claw button and the snap button are the most common buttons, so in the process of use, you will encounter some unexpected things, and due to the different structure of the button, the problems of each button are also different. . A five-claw clasp is a kind of button. Let's see what happens to a five-claw clasp?
Whether it is a four-button, an I-shaped button, a five-claw button, or a nail, the following principles should be adhered to when adjusting the mold:

Whether it is a four-button, an I-shaped button, a five-claw button, or a nail, the following principles should be adhered to when adjusting the mold:

When adjusting the pressure, the machine cannot be adjusted too deep. If the adjustment is too deep, it is easy to change the shape of the button, causing the button to be damaged or detached. If the adjustment is too shallow, the pressure is too small and the button is not easy to fall. The depth of hitting the die is based on experience. The easiest way is to hit the back button and pull it out forcefully with a vice.

No matter it is motor-driven, motive-driven, or foot-pressed, it is equally applicable. At that time, corning and air-eyeing also followed the above principles. So what aspects should the five-claw buckle pay attention to when binding?

1.hitting tightly and loosely. AIf the button is OK before the button is pressed, the button machine is adjusted too low. B may be mixed with products from other manufacturers. The C mode has problems.

2.The destructive power is not enough and it is easy to fall off. The closing height of A button machine is not adjusted well. BThe cloth is too thick or the claw length is not enough. The material of the C-claw is too thin and the hardness is not enough.

3.There are exposed claws. The top and bottom of the A button machine are not vertical, eccentric B The male and female buckle edges are too low or too narrow, and the gap with the claw is not enough (can be detected by hand before being hit) C If the claw surface has this condition, the claw may be too long Use short claws instead.

4.The paw breaks when you hit the button. A button machine tuning is too low. B's claw is too hard to bend. There is a problem with C plating, which makes the claws hard and brittle, especially the deplating (after plating the color, and then replating another color) is very likely to cause. The space and shape of the male and female buckles on the back are not good enough, so that the claw feet are not enough to break.

5.The paint comes off when the five-jaw clasp surface is painted. The shape of the A die does not match the shape of the claw surface. The paint quality of B is not good, and the adhesion of miscellaneous paint is generally poor. C. The oil was not cleaned before painting. DIf you use ironing, pay attention to the problem so as not to damage the paint.

The above information comes from the button industry website